Level Probe wiring on Black water and fresh water tank.
Author
Message
- Offline
- Site Admin
- Posts: 1233
- Joined: Wed Nov 19, 2014 2:26 pm
- Travco Model: 76 Mahal 2+2
- Location: Arnoldsville GA
- Contact:
Level Probe wiring on Black water and fresh water tank.
Does anyone know the wiring on the level probes for the black water tank? My black water tank was not wired up when I pulled it out so I have no idea what goes where. If someone knows it would save me a lot of time trying to check one wire combo at a time. The fresh water tank is also unwired but at least there the left the ends of the wires connected to the tank so I have something to go by.\nAny help is greatly appreciated.\n\n\nThanks \nPaul
- Offline
- Moderator
- Posts: 1199
- Joined: Sat Jan 26, 2013 2:32 am
- Travco Model:
- Location: Kerrville, Texas
Re: Level Probe wiring on Black water and fresh water tank.
All I can offer is an old picture of my blackwater tank. (see below) I doubt it will help you much though.
You do not have the required permissions to view the files attached to this post.
- Offline
- Site Admin
- Posts: 1233
- Joined: Wed Nov 19, 2014 2:26 pm
- Travco Model: 76 Mahal 2+2
- Location: Arnoldsville GA
- Contact:
Re: Level Probe wiring on Black water and fresh water tank.
That works quite well. \nIt should be about the same from 76 to 77.\nThank you very much
- Offline
- Site Admin
- Posts: 1782
- Joined: Tue Jan 22, 2013 7:01 am
- Travco Model: 1975 270,1974 220
- Location: North East Ct
Re: Level Probe wiring on Black water and fresh water tank.
I have owned several Travcos and yet to see one work so don't get your hopes up.. \nThat pic is different than the ones I have had though.
1977 Travco 270 Elite\n1974 Travco 220 Parts unit
- Offline
- Senior Contributor
- Posts: 629
- Joined: Fri Feb 21, 2014 10:32 am
- Travco Model: 270
- Location: Ohio
Re: Level Probe wiring on Black water and fresh water tank.
wouldn't it be feasible or should I say practical to just buy a new fluid level kit and be in total control of the level readings?\nLooking for opinions and options to get around poor or non working gauges and available kits..\nBBB
- Offline
- Site Admin
- Posts: 1233
- Joined: Wed Nov 19, 2014 2:26 pm
- Travco Model: 76 Mahal 2+2
- Location: Arnoldsville GA
- Contact:
Re: Level Probe wiring on Black water and fresh water tank.
My tank is different but that is the same probe set up.
- Offline
- Moderator
- Posts: 1199
- Joined: Sat Jan 26, 2013 2:32 am
- Travco Model:
- Location: Kerrville, Texas
Re: Level Probe wiring on Black water and fresh water tank.
Just for the record... both of my holding tank level indicators work. knock on wood.
- Offline
- Site Admin
- Posts: 1233
- Joined: Wed Nov 19, 2014 2:26 pm
- Travco Model: 76 Mahal 2+2
- Location: Arnoldsville GA
- Contact:
Re: Level Probe wiring on Black water and fresh water tank.
Considering I have the same probe setup it should work when I reconnect them. I will be putting the tank back in in a few minutes...\nThanks again 77.